HP-UX IPQoS A.01.00 Administrator's Guide (October 2005)
Table Of Contents
- About This Document
- 1 Introduction
- 2 Installing HP-UX IPQoS
- 3 Getting Started with HP-UX IPQoS
- 4 HP-UX IPQoS Configuration Files
- 5 Administering HP-UX IPQoS
- 6 Troubleshooting HP-UX IPQoS
- Overview
- Troubleshooting Tools
- Troubleshooting Scenarios
- Installation Scenario: HP-UX IPQoS Installation Fails
- HP-UX IPQoS Configuration File Verification Fails
- Active Configuration Is Not As Expected
- State Is Not As Expected
- Traffic Management Problems
- Corrupt or Missing HP-UX IPQoS Configuration File
- Internal Error from Corrupt or Missing HP-UX IPQoS Database File
- Sample Error and Warning Messages
- Reporting Problems to HP
- A HP-UX IPQoS Configuration File Attributes: Quick Reference
- B HP-UX IPQoS Configuration File Examples
- C ipqosadmin Quick Reference
- Glossary
Administering HP-UX IPQoS
Showing Configuration Information
Chapter 5 93
Policy: p0
Reservation: 60%
Max: 95%
Filter: f0
Destination address range: 20.0.0.0 - 20.255.255.255
Priority: 16
Policy: p1
Reservation: 15%
Max: 95%
Filter: f1
Destination address range: 30.0.0.0 - 255.255.255
Priority: 17
#
NOTE The Name: value shown at the beginning of the ipqosadmin -showconfig
output is always current.
Example 2
The following example displays output from ipqosadmin -showconfig when the state is
ENABLED but NOT FILTERING.
#ipqosadmin -showconfig
HP-UX IPQoS is ENABLED but NOT FILTERING.
#