HP-UX IPQoS A.01.00 Administrator's Guide (October 2005)
Table Of Contents
- About This Document
- 1 Introduction
- 2 Installing HP-UX IPQoS
- 3 Getting Started with HP-UX IPQoS
- 4 HP-UX IPQoS Configuration Files
- 5 Administering HP-UX IPQoS
- 6 Troubleshooting HP-UX IPQoS
- Overview
- Troubleshooting Tools
- Troubleshooting Scenarios
- Installation Scenario: HP-UX IPQoS Installation Fails
- HP-UX IPQoS Configuration File Verification Fails
- Active Configuration Is Not As Expected
- State Is Not As Expected
- Traffic Management Problems
- Corrupt or Missing HP-UX IPQoS Configuration File
- Internal Error from Corrupt or Missing HP-UX IPQoS Database File
- Sample Error and Warning Messages
- Reporting Problems to HP
- A HP-UX IPQoS Configuration File Attributes: Quick Reference
- B HP-UX IPQoS Configuration File Examples
- C ipqosadmin Quick Reference
- Glossary
Administering HP-UX IPQoS
Administering HP-UX IPQoS Operating States
Chapter 5 85
If the command is successful it reloads and re-initializes the HP-UX IPQoS Filtering module,
restores the state and configuration information saved at the time HP-UX IPQoS was
disabled (when /sbin/init.d/ipqos stop was run), and sets the log level to the value set in
the IPQOS_LOG_LEVEL parameter in the /etc/rc.config.d/ipqos file.
If the command fails, examine the displayed error messages to determine possible next steps.