HP-UX IPQoS A.01.00 Administrator's Guide (October 2005)

HP-UX IPQoS Configuration Files
Filter Blocks
Chapter 468
NOTE To use this shortcut, the transport protocol specified must be by name, not
by number. For example, specifying dstport http/6 is not allowed.
If a port is specified by a service name without the transport protocol immediately
following it, or if it specified as a number and the shortcut is not applicable, you can
specify the transport protocol value attribute separately, using the protocol attribute
(for example as protocol tcp), If the transport protocol is not specified either with the
service name or as a separate attribute, expanded filters are created for each protocol
number the service name converts to.
Additional Attributes
Additional filter attributes you can specify are listed below. You can combine these attributes
with address, port and priority attributes, or use any of these alone.
protocol n
Table 4-1 lists currently supported protocol assignments.
xport n
Same as protocol n above. Synonymous with protocol attribute.
net[proto] n
Network protocol number. For example, over Ethernet networks this
specifies the Ethertype frame.
NOTE IEEE and IEEE SNAP formats are similar enough that this
attribute works for both.)
Table 4-2 lists currently supported network protocol assignments.
Table 4-1 Supported Transport Protocol Numbers
Transport Protocol
Numbers
Protocol
6TCP
17 UDP