HP-UX IPQoS A.01.00 Administrator's Guide (October 2005)
Table Of Contents
- About This Document
- 1 Introduction
- 2 Installing HP-UX IPQoS
- 3 Getting Started with HP-UX IPQoS
- 4 HP-UX IPQoS Configuration Files
- 5 Administering HP-UX IPQoS
- 6 Troubleshooting HP-UX IPQoS
- Overview
- Troubleshooting Tools
- Troubleshooting Scenarios
- Installation Scenario: HP-UX IPQoS Installation Fails
- HP-UX IPQoS Configuration File Verification Fails
- Active Configuration Is Not As Expected
- State Is Not As Expected
- Traffic Management Problems
- Corrupt or Missing HP-UX IPQoS Configuration File
- Internal Error from Corrupt or Missing HP-UX IPQoS Database File
- Sample Error and Warning Messages
- Reporting Problems to HP
- A HP-UX IPQoS Configuration File Attributes: Quick Reference
- B HP-UX IPQoS Configuration File Examples
- C ipqosadmin Quick Reference
- Glossary
Installing HP-UX IPQoS
Installing HP-UX IPQoS
Chapter 2 39
Step 3. Follow steps 2-4 of the preceding procedure (Installing HP-UX IPQoS).
NOTE HP-UX IPQoS uses the standard HP-UX “newconfig” method of preserving the
original files by not overwriting them, but rather by creating files under
“newconfig” directories for new information. Thus, the HP-UX IPQoS
/opt/ipqos/db/ipqosdb.db (the active configuration database) and the
/etc/rc.config.d/ipqos files remain unchanged. New information is placed
into /usr/newconfig/opt/ipqos/db/ipqosdb.db and
/usr/newconfig/etc/rc.config.d/ipqos respectively.