HP-UX IPQoS A.01.00 Administrator's Guide (October 2005)

Troubleshooting HP-UX IPQoS
Troubleshooting Scenarios
Chapter 6104
Troubleshooting Scenarios
This section contains information about a few possible troubleshooting scenarios, including
symptoms and solutions.
Installation Scenario: HP-UX IPQoS Installation Fails
Problem
HP-UX IPQoS installation fails.
Symptoms
Output from running:
swinstall -x resinstall=true -s /tmp/IPQoS.depot HPUXIPQOS
indicates a failure or problem.
Solution
1. Verify that installation requirements have been met. See “System Requirements” on
page 35 for more information.
2. Examine the /var/adm/sw/swinstall.log and /var/adm/sw/swagent.log files for
messages indicating what the problem might be. Run swjob. The swjob arguments are
typically specified at the end of the swinstall process. The syntax is as follows:
swjob -a log hostname-# @ hostname:/.
3. If any problems are found, correct them and again try to install the software, by running
the following command:
swinstall -x resinstall=true -s /tmp/IPQoS.depot HPUXIPQOS
HP-UX IPQoS Configuration File Verification Fails
Problem
HP-UX IPQoS configuration file verification fails.
Symptoms
When you try to verify or load a configuration file, you get error messages.