Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

Chapter 2 33

Updating an Existing Operating System and Software

Updating HP-UX Software

NOTE Only HP 9000 servers listed in this table are supported for 64-bit

operation.

All systems not listed in the preceding table are supported only for 32-bit

operation.

There are different methods of determining your system’s ﬁrmware

revision, depending upon its system class. Using the command getconf

HW_CPU_SUPP_BITS will indicate your system’s bit compatibility. The

sections that follow detail the procedures for K-class, T-class, and V-class

servers.

Determining the Firmware Revision of

K-Class Servers

To determine the ﬁrmware revision on HP 9000 K-class servers, perform

the following steps.

Step 1. Determine which model of K-class you have by entering:

# model

9000/800/K380 32 and 64-bit 8 37.23

9000/804/K450 32 and 64-bit 36 37.40

9000/889/K460 32 and 64-bit 36 37.40

9000/889/K460-EG 32 and 64-bit 36 37.40

9000/889/K460-XP 32 and 64-bit 36 37.40

9000/899/K570 32 and 64-bit 8 37.23

9000/800/K580 32 and 64-bit 8 37.23

9000/893/T600 32 and 64-bit J537

9000/800/V2200 64 bit only All are 64-bit capable.

9000/800/V2250 64-bit only All are 64-bit capable.

Server model

HP-UX Version

Supported

Minimum

PDC

Revision

Minimum

Firmware

Revision