HP TFT7210R Installation Instructions

8. Attach the cable management arm to the rear of the HP
TFT7210R with two screws.
9. Route the cables through the cable management arm and
HP TFT7210R opening.
Removing the HP 1U Adjustable
Toolless Rails
1. Locate the spring release.
2. Place your hand on the outside of the HP 1U Adjustable
Toolless Rail so that you are able to move the spring
release.
3. Gently move the spring release toward the inside of the
rack (1) while moving the HP 1U Adjustable Toolless Rail
out toward you and away from the rack (2).
NOTE: If you cannot gain access to the spring release
from the outside of the HP 1U Adjustable Toolless Rail, a
tool might be required to unlock the spring release from
the unit side of the HP 1U Adjustable Toolless Rail.
4. Repeat the above steps for the other HP 1U Adjustable
Toolless Rail.