HP ThinPro 5.0 - Administrator Guide

Table E-13 root > Display (continued)
Registry key Description
4—Below
5—None
NOTE: This is hardware dependent and is not supported
on all models. The HP t5335z does not support two monitors.
root/Display/Configuration/secondaryorientation
root/Display/Configuration/secondaryprofile Specifies the profile name used for the second monitor.
root/Display/Configuration/swapstate Specifies which connector contains the primary monitor. This
is hardware-dependent and might not be implemented on all
models. Generally, 0 means the primary monitor is on the
VGA connector and 1 means the 'other' connector. For the
HP t5565z, 0 means the primary is on the DVI-I connector
and 1 means the primary is on the DVI-D connector. The HP
t5335z does not support two monitors.
root/Display/Configuration/tertiarymode If supported, specifies the position of the third monitor
relative to the primary monitor.
0—Same As
1—Above
2—Right Of
3—Left Of
4—Below
5—None
NOTE: This is hardware dependent and is not supported
on all models. The HP t5335z does not support two monitors.
root/Display/Configuration/tertiaryprofile Specifies the profile name for the third monitor.
root/Display/Configuration/tertiaryrelative Indicates which monitor is referenced to set the position of
the third monitor. See the tertiarymode key.
root/Display/Profiles/{UUID}/colorScaling The color temperature or direct RGB scaling for thin clients
with built-in monitors. The entry is a six-digit hex value
RRGGBB, where ffffff would indicate full (100%) scaling on
all three color channels.
root/Display/Profiles/{UUID}/depth The display bit depth per pixel. A higher bit depth means
better quality, but more data and thus a lower performance.
root/Display/Profiles/{UUID}/height The desired monitor resolution width. A value of 0 means
auto-detect the resolution.
root/Display/Profiles/{UUID}/label Display profile name. This should be default.
root/Display/Profiles/{UUID}/orientation Specifies monitor orientation:
0—Normal
1—Rotate left
2—Rotate right
3—Invert
root/Display/Profiles/{UUID}/refresh Specifies the desired monitor refresh rate; not all refresh
rates are supported for all resolutions. The values supported
root > Display 125