HP Smart Zero Core 4.3 Administrator's Guide

Table C-1 root > Audio (continued)
Registry key Valid values Description
root/Audio/OutputMute 1—Mute the internal speaker and
headphone jack.
0—Do not mute the internal speaker
and headphone jack.
Not applicable
root/Audio/OutputVolume 1–100 Indicates the volume setting for the
internal speaker and headphone jack,
scaling from 1 to 100.
root/Audio/PlaybackDevice 1 is the internal audio controller.
2 and 3 are for additional devices, such
as a USB headset.
The device to use for playback.
root/Audio/RecordMute 1—Mute the microphone jack.
0—Do not mute the microphone jack.
Not applicable
root/Audio/RecordVolume 1–100 Indicates the volume setting for the
microphone jack, scaling from 1 to 100.
root/Audio/VisibleInSystray 0—Icon is not visible
1—Icon is visible
Indicates whether a speaker icon is
visible in the system tray.
root > ConnectionManager
This section describes the registry keys, functions, options, and descriptions in the root >
ConnectionManager folder.
Table C-2 root > ConnectionManager
Registry key Valid values Description
root/ConnectionManager/
customLogoPath
root/ConnectionManager/
defaultConnection
[type]:[label] This must be set to a valid connection
using the format '[type]:[label]' to
properly launch a connection at startup.
For example, 'xen:Default Connection'.
root/ConnectionManager/
splashLogoPath
Indicates the full path to the default
image displayed while a connection is
loading.
This is the splash screen that will be
seen after clicking Connect on the HP
ThinPro control panel.
root/ConnectionManager/
useKioskMode
root/ConnectionManager/
useSplashOnConnectionStartup
Set to '1' to enable the splash screen
image specified by 'splashLogoPath' on
connection startup.
By default, this is disabled on HP Smart
Zero Core and enabled on HP ThinPro.
root > ConnectionType
This section describes the registry keys, functions, options, and descriptions in the root >
ConnectionType folders as follows.
root > ConnectionManager 59