HP ThinPro 4.2 Administrator's Guide

RGS
1. To add an RGS connection, click Connections > Add > RGS.
2. Set the appropriate configuration options:
NOTE: For more information about RGS, see the HP Remote Graphics Software User Guide.
Table 3-25 New RGS connection configuration settings
Option Description
Name The connection name.
Mode - Servers
Select one of the RGS connection modes, either Normal Mode or Directory
Mode.
If you select Normal Mode, type the hostname or IP address of the system
running the RGS Sender.
If you select Directory Mode, type the path of the Directory file.
Warning Timeout
Set the appropriate Warning Timeout value. The RGS Receiver will display a
warning if it fails to detect the RGS Sender after this value in seconds.
Error Timeout
Set the appropriate Error Timeout value. The RGS Receiver will end the
connection if it fails to detect the RGS Sender after this value in seconds.
Use Global Image Updates
When enabled, the entire screen will be updated instead of just the parts that
changed.
Borders
Select one of the following values: Off, On, or Use Previous Setting.
NOTE: If you set the borders to Off, the window will not have the borders
that allow it to be moved, resized, or minimized.
Click Next to continue.
3. Set the appropriate advanced options (refer to
Table 3-10 New connection advanced settings
on page 9).
4. Click Finish to save your settings and close the dialog box.
VMware View
PC-over-IP (PCoIP) is a communications protocol integrated into VMware that enables remote
access to virtual machines.
1. To add a VMware View connection, click Connections > Add.
2. Select VMware View and set the appropriate network options:
Table 3-26 VMware View connection network settings
Option Description
Name The connection name.
Server The name of the remote server.
Username The username to use for the connection.
Password The password to use for the connection.
16 Chapter 3 Reference