HP Easy Tools Administrator's Guide

9. Configure the Peripherals:
a. Display
(Required) Set the following parameters:
●
Resolution—Select the monitor resolution.
●
Color depth—Select a specific color depth supported by the monitor and the software.
●
Refresh rate—Select the refresh rate applicable to your display/monitor. LCD
monitors typically support 60 Hz. CRT monitors display better at higher refresh rates, but
that may shorten the life of the monitor and can cause noise.
●
Multi-monitor mode—Select the screen arrangement for multiple monitors (for up to
four monitors).
●
Primary monitor—Select the primary monitor, if more than one monitor will be used.
b. Power Management
Type or select the number of minutes in the Screen saver on field. After this specified
period of inactivity, the screen saver is displayed.
c. Wireless Networking
●
SSID—Type the Service set identifier (SSID) of the 802.11 wireless local area network
(LAN) in the field.
●
Security—Select the security option.
●
Passphrase—If you selected a security option other than None, type a password in
the field:
◦
WEP 40-bit: 10 hexadecimals
◦
WEP 104-bit: 26 hexadecimals
◦
WPA Personal and WPA2 personal: 8 to 63 printable characters
d. Sound
Select Enable to allow sound or leave the check box clear to keep it switched off.
e. USB Mass Storage
●
Select Enable to enable USB ports, or leave the check box clear to keep USB ports
disabled.
●
Select Read only storage to prevent data from being copied to a USB mass storage
device.
Easy Config
71