HP Smart Client Administrator's Guide

/* Flat gray */
background: rgb(204,204,204);
border-radius: 3;
color: rgb(102,102,102);
font-size: 12pt;
}
Of course, many more customizations are possible. See the Qt documentation for possibilities.
Saving profiles
This screen shows the contents of the profile and allows it to be saved.
The profile can also be saved by clicking Finish in the Current Profile page of the Profile Editor.
Parallel and serial printer porting
Parallel and serial printing can be set up in the Profile Editor. Further setup can then be done via the
Printers and Faxes wizard. This only applies to those two printer types; a USB printer is automatically
configured to map when it is plugged in. The Profile Editor requires the first three steps for either serial
or parallel printer. Steps 4 to 6 are required only for a serial printer.
NOTE: You will need your serial printer’s baud rate in order to set up the printer. If you do not know
this, on most printers, you can press and hold the FEED button and turn the printer on. After a few
seconds, release the FEED button and the printer will enter a Testing mode and print out the required
information. You may need to turn the printer off to cancel the Test mode or press FEED again to make
it print the diagnostic page.
1. From the Profile Editor, configure an RDP or VMWare View connection.
2. In the Registry Editor, select the Show all settings check box.
3. In the Registry Editor, go to root\ConnectionType\rdesktop\connections\{UUID}\mapSerial or
root\ConnectionType\view\connections\{UUID}\mapSerial and change its value to 1.
4. In the Registry Editor, create a new directory under Root called Serial.
5. Under Serial, create a new setting called Baud.
6. Set the Baud value to the baud rate of your serial printer.
NOTE: If you connect using VMWare, as it originally starts to connect, make sure you cancel the
connection. You need to change it—click the down arrow next to the connection, select Connection,
and then select Microsoft RDP.
When you connect to your server via RDP or VMWare View, use these steps to install the printer:
1. Click Start > Printers and Faxes.
2. Click Add Printer in the new window and click Next.
32 Chapter 2 Server setup