Hardware Reference Guide HP t505 Flexible Thin Client

Removing and Replacing the Side Access Panel
Removing the Side Access Panel
WARNING! Before removing the side access panel, ensure that the thin client is turned off and the
power cord is disconnected from the electrical outlet.
To remove the access panel:
1. Lay the unit flat on a stable surface with the right side up and the left side down.
2. Remove the two screws that secure the access panel to the chassis (1).
3. Slide the access panel about 8.3 mm (1/3 inch) toward the rear of the unit (2), and then lift the
access panel up and off the unit (3).
Figure 2-1 Removing the side access panel
10 Chapter 2 Hardware Changes