Hardware Reference Guide HP t505 Flexible Thin Client

3. Align the feet with their holes and press them in securely.
Figure 1-3 Installing the rubber feet
Installing the Stand
If you wish to use the thin client in a vertical orientation, you should install the stand for stability.
To install the stand:
1. Turn unit upside down.
2. Locate the slots on the bottom of the unit into which the tabs on the stand fit. Position the stand with
the wide part toward the front of the unit. Align the tabs on the widest part of the stand with the
slots approximately 7.6 cm (3 inches) from the front of the unit and the tabs on the narrower part
with the slots approximately 3.8 cm (1.5 inches) from the rear of the unit.
4 Chapter 1 Product Features