HP Smart Zero Core 4.3 Administrator's Guide

Table C-7 root > Network (continued)
Registry key Description
root/Network/IPSec/IPSecRules/{UUID}/
QMESPEncryptionAlg
Phase 2 ESP encryption algorithm.
root/Network/IPSec/IPSecRules/{UUID}/QMESPIntegrityAlg Phase 2 ESP integrity algorithm.
root/Network/IPSec/IPSecRules/{UUID}/QMLifetimeSeconds Phase 2 lifetime.
root/Network/IPSec/IPSecRules/{UUID}/RuleDescription Description for the IPsec rule, such as purpose for creating
the rule.
root/Network/IPSec/IPSecRules/{UUID}/RuleEnable Rule enable or disable flag. When set to 1 the rule will be
enabled. Set to 0 to disable the rule.
root/Network/IPSec/IPSecRules/{UUID}/RuleName Name of the IPsec rule.
root/Network/IPSec/IPSecRules/{UUID}/SrcAddr Source address for the IPsec rule.
root/Network/IPSec/IPSecRules/{UUID}/TunnelDstAddr Tunnel destination address for the IPsec rule.
root/Network/IPSec/IPSecRules/{UUID}/TunnelEnable Enables tunnel setting for the IPsec rule. When enabled, the
rule is 'apply to tunnel mode'.
root/Network/IPSec/IPSecRules/{UUID}/TunnelSrcAddr Tunnel source address for the IPsec rule.
root/Network/SearchDomains Additional search domains for FQDN resolution can be
specified here. The specified domains will be appended to
any incomplete server definitions in an attempt to generate
an FQDN that can be resolved through DNS. For example, a
search domain of 'mydomain.com', will allow the server
definition 'myserver' to resolve properly to
'myserver.mydomain.com' even if the DNS server does not
have 'myserver' in its name resolution tables. Up to five
additional search domains can be specified.
root/Network/VPN/AutoStart Auto-starts VPN on system boot.
root/Network/VPN/Domain VPN domain.
root/Network/VPN/Gateway VPN gateway.
root/Network/VPN/Group VPN group.
root/Network/VPN/GroupPassword VPN group password.
root/Network/VPN/Password VPN user password.
root/Network/VPN/Type VPN type.
root/Network/VPN/Username VPN user name.
root/Network/Wired/DefaultGateway The default gateway the device will use to communicate to
the internet. Typically, this is the address of the router.
NOTE: This setting will take effect only when 'Method' is
set to 'Static'.
root/Network/Wired/EthernetSpeed The link speed of the primary ethernet network interface.
Automatic will allow it to choose the fastest available link
speed, (usually 1 Gbps or 100 Mbps depending on the
switch). The link speed can also be forced to a single speed
(100 Mbps or 10 Mbps) and duplex mode (full or half) to
support switches or hubs that do not perform appropriate
auto-negotiation.
root/Network/Wired/Interface The default ethernet interface or NIC.
80 Appendix C HP Smart Zero Core registry settings