HP Smart Zero Core 4.3 Administrator's Guide

Table C-6 root > Display (continued)
Registry key Description
2—Right Of
3—Left Of
4—Below
5—None
NOTE: This is hardware-dependent and is not supported
on all models. The HP t5535z does not support two monitors.
root/Display/Configuration/swapstate Specifies which connector contains the primary monitor. This
is hardware-dependent and might not be implemented on all
models. Generally, 0 means the primary monitor is on the
VGA connector and 1 means the 'other' connector. For the
HP t5565z, 0 means the primary is on the DVI-I connector
and 1 means the primary is on the DVI-D connector. The HP
t5335z does not support two monitors.
root/Display/Profiles/{UUID}/colorScaling The color temperature or direct RGB scaling for thin clients
with built-in monitors. The entry is a six-digit hex value
RRGGBB, where ffffff would indicate full (100%) scaling on
all three color channels.
root/Display/Profiles/{UUID}/depth The display bit depth per pixel. A higher bit depth means
better quality, but more data and thus a lower performance.
root/Display/Profiles/{UUID}/height The desired monitor resolution width. A value of 0 means
auto-detect the resolution.
root/Display/Profiles/{UUID}/label Display profile name. This should be default.
root/Display/Profiles/{UUID}/orientation Specifies monitor orientation:
0—Normal
1—Rotate left
2—Rotate right
3—Invert
root/Display/Profiles/{UUID}/refresh Specifies the desired monitor refresh rate; not all refresh
rates are supported for all resolutions. The values supported
by the client depend on the monitor. A value of 0 means
auto-detect the refresh rate.
IMPORTANT: Picking a refresh rate that is not supported
by the monitor attached to the client results in a black
screen. HP recommends leaving this set to 0.
root/Display/Profiles/{UUID}/width The desired monitor resolution width. A value of '0' means
auto-detect the resolution.
root > Network
This section describes the registry keys, functions, options, and descriptions in the root > Network
folder.
78 Appendix C HP Smart Zero Core registry settings