HP Smart Zero Core 4.3 Administrator's Guide

Table C-5 root > ConnectionType > xen (continued)
Registry key Description
root/ConnectionType/xen/gui/XenManager/widgets/
autoReconnect
root/ConnectionType/xen/gui/XenManager/widgets/autostart
root/ConnectionType/xen/gui/XenManager/widgets/
autoStartDesktop
root/ConnectionType/xen/gui/XenManager/widgets/
autoStartResource
root/ConnectionType/xen/gui/XenManager/widgets/domain
root/ConnectionType/xen/gui/XenManager/widgets /
enablePNADesktopIcons
root/ConnectionType/xen/gui/XenManager/widgets/
enablePNAStartMenuItems
root/ConnectionType/xen/gui/XenManager/widgets/
fallBackConnection
root/ConnectionType/xen/gui/XenManager/widgets/folder
root/ConnectionType/xen/gui/XenManager/widgets/
hasDesktopIcon
root/ConnectionType/xen/gui/XenManager/widgets/isInMenu
root/ConnectionType/xen/gui/XenManager/widgets/label
root/ConnectionType/xen/gui/XenManager/widgets/password
root/ConnectionType/xen/gui/XenManager/widgets/
username
root/ConnectionType/xen/gui/XenManager/widgets/
waitForNetwork
root > Display
This section describes the registry keys, functions, options, and descriptions in the root > Display
folder.
Table C-6 root > Display
Registry key Description
root/Display/Configuration/displaymode Specifies the display mode of the unit. A value of 0 denotes
standard mode (1–4 monitors), whereas a value of 1 denotes
a 6-monitor mode. The HP t610 with the appropriate add-on
card is the only supported hardware.
root/Display/Configuration/primaryprofile This must always be set to default.
root/Display/Configuration/secondarymode If supported, specifies the position of the secondary monitor
relative to the primary monitor.
0—Same As
1—Above
root > Display 77