HP Systems Insight Manager 7.2 Technical Reference Guide

You can also edit the globalsettings.props file and modify the EmailKeywords property.
Configuring e-mail settings, in the "EmailSettings" section for additional information on changing
the EmailKeywords property.
For SNMP traps, the MIB cfg file is the default location that HP SIM looks for keywords. If keywords
are not defined here, then HP SIM looks at the EmailKeywords property in the
globalsettings.props file.
Related information
Configuring status change events
Perform the following procedure to configure the sending of status change events for systems when
hardware status changes to and from a Critical (unreachable) state only.
Procedure 164 Configuring status change events
1. Select one of the following options.
• Enable creation of system status change events. This option sends a system unreachable
event whenever a system cannot be reached by a ping through the Hardware Status
Polling task. Enabling this option creates a system reachable event whenever the system
is reachable again.
• Automatically clear unreachable system status change events when system is reachable.
If this option is enabled, when a system that was previously unreachable starts to respond,
the previous unreachable event is marked with a cleared state.
2. Click OK to apply changes.
Related information
Subscribing to WBEM indications
Procedure 165 Subscribing to WBEM indications
1. Select Options→Events→Subscribe to WBEM Events. The Step 1: Select Target Systems page
appears.
2. Select the target systems, and then click Apply. The Step 1: Verify Target Systems page appears.
3. Click Next. The Step 2: Task Confirmation page appears and provides details about the task
that was created.
4. Click Run Now to add subscriptions for WBEM events on the target systems. The Task Results
page appears.
Related information
Unsubscribing to WBEM indications
Procedure 166 Unsubscribing to WBEM indications
1. Select Options→Events→Unsubscribe to WBEM Events. The Step 1: Verify Target Systems page
lists all of the targets with subscriptions to WBEM indication events.
2. If you do not want to delete a target's WBEM indication events subscription, select the target
and click Remove Targets.
3. Click Next. The Step 2: Task Confirmation page appears and provides details about the task
that was created.
4. Click Run Now to remove subscriptions for WBEM indication events on the target systems.
The Task Results page appears.
Instead of clicking Run Now, you can click Schedule to schedule the task for a later time. See
Scheduling a task for more information.
Configuring status change events 289