HP Systems Insight Manager 7.2 Technical Reference Guide

Procedure 82 Deleting system credentials
1. The following tabs are available on the Edit System Credentials page:
• Sign in
This tab enables you to set one credential for all protocols.
• SNMP
This tab enables you to set one SNMP community string.
For advanced, and protocol-specific settings, click Show advanced protocol credentials
to the right of the tabs. The following additional tabs appear.
• SNMPv3
This tab enables you to set SNMP3v specific security parameters.
• WBEM/WMI
This tab enables you to set WBEM credentials.
• WS-MAN
This tab enables you to set WS-MAN credentials.
• SSH
This tab enables you to configure SSH credentials.
• Single Sign On
This tab enables you to set the trust by certificate relationship.
• VME
This tab enables you to set VME credentials that were configured on the VMWare vCenter
Server Web Services page during VMWare vCenter Server installation. This is not
available when creating a discovery task until after the VMWare vCenter servers are
discovered.
2. Make all of the credential information for the system blank. For multiple systems, you must
make all of the credentials for each system blank.
3. To delete cleared credentials, click OK.
Sign-in credentials
Sign-in credentials are protocol independent. For performance reasons, a maximum of 10 systems
can be edited individually at one time.
System credentials 233