HP Systems Insight Manager 7.2 Technical Reference Guide

10 identified, you have: 50/100 * .10 = 0.05 (ping sweep) 10/100 * .90 = 0.09 (identification)
0.05 + 0.09 = 0.14 * 100 = 14% (total completed percentage).
NOTE: You can run only one discovery task at a time. If you select to run more than one discovery
task, the percentage in the Last Run column remains at 0% until the currently running task is complete.
For all automatic discoveries section
The following options are available:
• Configure general settings
Select this option to configure settings that apply to all discovery tasks. For more information,
see Configuring discovery general settings.
• Manage hosts files
Select this option to manage hosts files. For more information, see Managing Hosts files.
• Configure global protocol settings
Select this option to configure global protocol settings. For more information, see Protocol
settings.
NOTE: To discover clusters correctly, you must enable SNMP with the correct security settings
on HP SIM on the target systems.
Actions to take after running discovery section
This section is available only when Insight managed system setup wizard or HP Insight Control
virtual machine management is installed and the available options include:
• Run the managed system setup wizard
This option is available when Insight managed system setup wizard is installed and takes you
to the Insight managed system setup wizard page to configure managed systems.
Discovery page buttons
From the Discovery page, you can also:
• Create a new discovery task
Click New and the New Discovery section appears. For more information, see Creating a
new discovery task. For HP recommended discovery tasks, see Recommended discovery tasks.
• Edit an existing discovery task
Select a task from the table, and click Edit. The Edit Discovery section appears. For more
information, see Editing a discovery task.
• Enable or disable a discovery task
Select a task and click Disable to disable the schedule of an enabled task. If a task is disabled,
the button changes to Enable. To resume automatic execution of the task, click Enable. For
more information, see Disabling or enabling an existing discovery task.
• Delete an existing discovery task
Select a task from the table and click Delete. For more information, see Deleting a discovery
task.
• View Task Results
Displays the task results for the current discovery task.
192 Operations