Linux Trap ID and SNMP Traps Reference Guide For use with SmartStart version 8.30

Page 46 of 53
Symptom: Server blade removed. The server blade has been removed from the enclosure.
User action: None
Supporting SNMP trap data:
 sysName
 cpqHoTrapFlags
 cpqRackName
 cpqRackUid
 cpqRackServerBladeEnclosu reName
 cpqRackServerBladeName
 cpqRackServerBladePosition
 cpqRackServerBladeSparePartNumber
 cpqRackCommonEnclosureSerialNum
 cpqRackCommonEnclosu reTrapSequenceNu m
Supporting SNMP trap description: “Server blade [cpqRackServerBladeName] removed from position
[cpqRackServerBladePosition], in enclosure [cpqRackServerBladeEnclosureName], in rack
[cpqRackName].”
22029 - cmahealthd
Log message: “Server blade inserted”
SNMP trap: cpqRackServerBladeInserted - 22029 in CPQRACK.MIB
Symptom: Server blade inserted. The server blade has been inserted into the enclosure.
User action: None
Supporting SNMP trap data:
 sysName
 cpqHoTrapFlags
 cpqRackName
 cpqRackUid
 cpqRackServerBladeEnclosu reName
 cpqRackServerBladeName
 cpqRackServerBladePosition
 cpqRackServerBladeSparePartNumber
 cpqRackCommonEnclosureSerialNum
 cpqRackCommonEnclosu reTrapSequenceNu m
Supporting SNMP trap description: “Server blade [cpqRackServerBladeName] inserted into position
[cpqRackServerBladePosition], in enclosure [cpqRackServerBladeEnclosureName], in rack
[cpqRackName].”
22030 - cmahealthd
Log message: “Power subsystem not load balanced.”
SNMP trap: cpqRackPowerChassisNotLoadBalanced - 22030 in CPQRACK.MIB
Symptom: Power subsystem not load balanced. The power subsystem is out of balance for this power
enclosure.
User action: Check the power enclosure and power supplies. Replace any failed or degraded power
supplies. Add additional power supplies if needed.
Supporting SNMP trap data:
 sysName
 cpqHoTrapFlags
 cpqRackName
 cpqRackUid
 cpqRackCommonEnclosureName
 cpqRackCommonEnclosureSerialNum
 cpqRackCommonEnclosureSparePartNumber
 cpqRackCommonEnclosu reTrapSequenceNu m
Supporting SNMP trap description: “Power subsystem not load balanced in enclosure