Linux Trap ID and SNMP Traps Reference Guide For use with SmartStart version 8.30

Page 34 of 53
Supporting SNMP trap description: “The Advanced Memory Protection subsystem has engaged the
online spare memory.”
6048 - cmahealthd
Log message: “The power supply is OK.”
SNMP trap: cpqHe4FltTolPowerSupplyOk - 6048 in CPQHLTH.MIB
Symptom: The fault tolerant power supply condition has been set back to the OK state for the specified
chassis and bay location.
Supporting SNMP trap data:
 sysName
 cpqHoTrapFlags
 cpqHeFltTol PowerSu pplyChassis
 cpqHeFltTolPowerSupplyBay
 cpqHeFltTolPowerSupplyStatus
 cpqHeFltTolPowerSupplyModel
 cpqHeFltTolPowerSupplySerialNumber
 cpqHeFltTolPowerSupplyAutoRev
 cpqHeFltTolPowerSupplyFirmwareRev
 cpqHeFltTolPowerSupplySparePartNum
 cpqSiServerSystemId
Supporting SNMP trap description: “The Power Supply is OK on Chassis
[cpqHeFltTolPowerSupplyChassis], Bay [cpqHeFltTolPowerSupplyBay], Status
[cpqHeFltTolPowerSupplyStatus], Model [cpqHeFltTolPowerSupplyModel], Serial Num
[cpqHeFltTolPowerSupplySerialNumber], Firmware [cpqHeFltTolPowerSupplyFirmwareRev].”
6049 - cmahealthd
Log message: “The power supply has degraded.”
SNMP trap: cpqHe4FltTolPowerSupplyDegraded - 6049 in CPQHLTH.MIB
Symptom: The fault tolerant power supply condition has been set to Degraded for the specified chassis
and bay location.
Supporting SNMP trap data:
 sysName
 cpqHoTrapFlags
 cpqHeFltTol PowerSu pplyChassis
 cpqHeFltTolPowerSupplyBay
 cpqHeFltTolPowerSupplyStatus
 cpqHeFltTolPowerSupplyModel
 cpqHeFltTolPowerSupplySerialNumber
 cpqHeFltTolPowerSupplyAutoRev
 cpqHeFltTolPowerSupplyFirmwareRev
 cpqHeFltTolPowerSupplySparePartNum
 cpqSiServerSystemId
Supporting SNMP trap description: “The Power Supply is Degraded on Chassis
[cpqHeFltTolPowerSupplyChassis], Bay [cpqHeFltTolPowerSupplyBay], Status
[cpqHeFltTolPowerSupplyStatus], Model [cpqHeFltTolPowerSupplyModel], Serial Num
[cpqHeFltTolPowerSupplySerialNumber], Firmware [cpqHeFltTolPowerSupplyFirmwareRev].”
Trap IDs: 6050-9010
6050 - cmahealthd
Log message: “The power supply has failed.”
SNMP trap: cpqHe4FltTolPowerSupplyFailed - 6050 in CPQHLTH.MIB
Symptom: The fault tolerant power supply condition has been set to Failed for the specified chassis and
bay location.