HP System Management Homepage

Related Procedures
• IP Binding
• IP Restricted Login
• Local Server Certificate
• Alternative Names Certificates
• Port 2301
• Timeouts
• Trust Mode
• Trusted Management Servers
• Kerberos Authorization Procedure
• User Groups
Related Topic
▲ The Settings Page
IP Binding
IP Binding specifies the IP addresses that HP SMH accepts requests from and controls the nets and subnets
that requests are processed.
Administrators can configure HP SMH to only bind to addresses specified in the IP Binding window. Five
subnet IP addresses and netmasks can be defined.
An IP address on the server is bound if it matches one of the entered IP Binding addresses after the mask is
applied.
HP SMH supports IPv4 and IPv6 addresses.
NOTE: HP SMH always binds to 127.0.0.1. If IP Binding is enabled and no subnet/mask pairs are
configured, HP SMH is only available to 127.0.0.1. If IP Binding is not enabled, you bind to all addresses.
To configure IP Binding:
1. Select Settings from the menu.
2. In the System Management Homepage box, click the Security link.
3. Click the IP Binding link.
4. Enter the Subnet IP Address.
You can enter IPv4 or IPv6 addresses.
5. Enter the Netmask.
6. Click Add to add the Subnet IP Address and Netmask that were entered in the preceding steps.
You can add up to five subnet IP addresses and netmasks by repeating steps 4 through 7.
7. Click Apply to apply the configurations.
NOTE: The netmask is applicable only for IPv4 addresses.
To remove IP addresses from the list:
1. Select Settings from the menu.
2. In the System Management Homepage box, click the Security link.
3. Click the IP Binding link.
4. Select the checkbox beside the IP address you want to remove.
5. Click Remove.
6. Click Apply to apply the configurations.
Security 33