HP SVA V2.1 System Administration Guide

TIP: HP recommends that within a single display node, you use a single type of display device
(DVI, VGA). If you mix types, you will likely need to swap graphics cables until the screen is
properly configured. This is not an issue when using a KVM.
Figure 2-1 Cabling Reference xw8200, xw8400, xw9300, xw9400: Graphic Card Ports
Cable to flat panelCable to flat panel
765 43 2 1
A B
1
2
Figure 2-2 Cabling Reference DL140 G3, DL145 G3: Graphic Card Ports
Display Cables
1
2
Figure 2-3 Cabling Reference for Multi-Tile Display Blocks: Two Cards
A,2
A,1
B,2
B,1
A,2
A,1
B,2
B,1
A,2
B,2
B,1
A,2
B,2
A,2 A,1 B,2 B,1
A,2 B,2 B,1
A,2 B,2
Figure 2-4 Cabling Reference for Multi-Tile Display Blocks: One Card
A,2
A,1
A,2 A,1
A,2
2.2 Physically Install Display Nodes and Display Devices 29