HP Scalable Visualization Array Version 1.1 System Administration Guide

Figure 1-5 Creating a 2 W x 2 H Display Surface
Display Surface
(2 W x 2 H)
Vis4
Vis3
Display Nodes
File View
Two Tiles
Two Display
Blocks: 2 W
x 1 H
Two Tiles
To create such a Display Surface, follow these steps:
1. Begin by choosing the Create option and entering the name for the new Display Surface.
At this point, you will see a list of the available display blocks, for example:
Width Height Number of Nodes
1) 1 1 2
2) 2 1 2
3) 2 2 2
4) 1 4 2
2. Pick the type of display block you want to use. In this case, you enter the number 2 because you want
to use 2 W x 1 H display blocks.
Pick a display block:
2
3. For this example, you would enter the following display block arrangement:
What is the width of the display surface (in display blocks)?
1
What is the height of the display surface (in blocks)?
2
You have chosen a display surface that will look like the diagram below:
+====+
| 2 |
+====+
| 1 |
+====+
4. Next, specify the host name of the display node for each display block, in this case two display nodes
for the two display blocks, which correspond to four display devices. Note that at the prompt, pressing
30 SVA System Administration Tasks