HP Scalable Visualization Array, V1.1 Software Installation Guide

Installing Remote Graphics Software
If you plan to use RGS on an HP XC cluster, you must do several things in addition to the normal HP RGS
installation steps.
1. Install HP RGS on the cluster head node. If you are doing an initial installation of an HP XC cluster,
follow the Install Required Third Party Software (Optional) step of the HP XC installation.
2. Follow the normal RGS sender installation instructions.
3. Carry out the HP XC cluster_config process and golden image update procedures. Note the
following:
• You must use cluster_config to configure an external NIC on each node on which you want
to use RGS.
• After the cluster_config process asks you about display nodes, it asks about remote graphics
nodes. Enter the names of cluster nodes you want to use with HP RGS here.
• Bear in mind that nodes that uses HP RGS have an open firewall.
Installing Remote Graphics Software 17