HP SureStore E Tape Library Model 6/140 User's Guide

Getting Started
Moving or Shipping the Library
Chapter 11-36
b. Pull the unlocked door(s) out to access magazines and tapes. The
door may also be key locked. Unlock the door if needed.
c. Remove the magazine by lifting it straight up with the handle.
d. To remove a tape, set the magazine on its back and grasp the top
and bottom corners of the tape. Pull the tape straight out of the
magazine and return the magazine to the library.
4. If shipping the library, lock the transport:
a. From the
Administration menu, select the Run Test menu.
b. From
Run Test, use the [-] or [+] keys to select Lock Transport.
c. Select
[OK].
d. Select
[Run]. The front panel display will indicate that the
transport has been locked.
CAUTION Do not power off the library until the interface is inactive. Removing
power from a SCSI or Fibre Channel peripheral when the bus is active can
result in data loss and/or indeterminate bus states. If your computer is
connected to a LAN, be sure to check with your system administrator
before powering off the library.
5. Power off the library. The power “standby” switch is recessed to avoid
accidental power cycles.
6. To ship the library, remove all external cables and terminators. For an
internal move, only disconnect the power cable, SCSI cables, the RMC
ethernet cable, and the Fibre Channel connection from the host, hub,
or switch.
NOTE You do not need to remove the SCSI cables that connect the controller or
the Fibre Channel interface to the drive modules, unless the library is
being shipped.