Hardware Operator's Guide
Hardware Operator’s Guide
X–2
DLT Library
!!' ##" $ The library menu
offering library utility selections.
# The mechanism used by the library
robot to open and close tape drives for mounting
and dismounting cartridge tapes.
M
Meter.
$ The top–level menu on the
operator panel display.
$" A hierarchical list of selections on the
library operator panel, providing the user interface
to the library.
Millimeter.
" Megabytes per second.
$# To insert a cartridge into a drive.
Millivolt.
O
!#! The user interface to the
library.
!#! #!" The MENU,
ENTER, Up and Down Arrows, and SYSTEM
RESET buttons on the library operator panel.
!#! " The Library Active,
CAP Open, and Service Required LEDs on the
library operator panel.
P
! " The mechanism on the
hand/camera assembly that latches onto cartridge
tapes and pulls them into the hand.
$" !" Two levers on the picker
mechanism that push the cartridge into a storage
cell.
R
!# The mechanism that moves cartridge tapes
to and from the storage cells, CAP, and tape drives.
S
"#' #! "&# A switch that
disconnects power to the library when the front
door is opened.
Small Computer System Interface.
% A host adapter or control unit
attached to the SCSI bus.
# $!# $ The library menu
offering library and drive configuration selections.
" A SCSI bus configuration
offering a maximum cable length of 6 meters (25
feet).
"#!#$ !$# An initialization and diagnostic
routine performed automatically by the library
when it is powered on or reset.
"##$" " ' A page showing library and
drive status on the operator panel display.
"#! " The slots where cartridge tapes are
kept in the library.
T
## #! The motor driving the belt that
moves the library robot in horizontal rotation.
V
Volts or voltage.
Volts alternate current (AC).
Volts direct current (DC).
Volume serial number.
%$ "! $! The code used by the
library to track cartridge tapes during library audits
and normal operation.
W
&!# A setting on tape cartridges
allowing data to be written.
&!# !## A setting on tape cartridges
preventing data from being written. Reading data
is still possible.
Z
$ The part of the library robot
responsible for vertical motion of the hand/camera
assembly.