Expansion Frame Installation Guide

62108 6
CAUTION: Be careful not to hit your head on the theta lock down bracket mounted to the
top inside surface of the tape library frame.
18. From the inside of the cartridge area, install six 1/4-20 x 1/2-in. long screws, using a T30
Torx driver, through the holes in the tape library frame into the expansion frame (see
Figure 2 for screw locations) and tighten.
19. Using a T15 Torx driver, reinstall the plate to the left side of the drive using the 12 No.6-
32 screws previously removed in Step 7.
Figure 3. Expansion Frame Alignment
Expansion Frame Alignment (a5605a_03)
1. Top Locating Pin
2. 1/4-20 x 1/2-in. Torx Screw (6x)
3. Expansion Frame
4. Leveling Bolt (4x)
5. Bottom Locating Pin