Expansion Frame Installation Guide

62108 5
CAUTION: Heavy Load. At least three people are required to remove the Expansion
Frame from packaging and push it into position.
12. Remove the expansion frame from its package and place it flat on the floor.
13. Measure the distance from the floor of the room to the inside floor of the tape library (see
Figure 2).
14. Adjust the leveling bolts (4 places) on the expansion frame (measured from the inside
floor of expansion frame to the bottom of the leveling bolt) to be 1/16-inch to 1/8-inch
shorter than what was measured in Step 13.
15. Stand the expansion frame up on the leveling bolts and position it against the frame of the
tape library. Be careful not to bend the leveling bolts when moving the expansion frame
into position.
16. To correctly align the expansion frame with the tape library:
• Align bottom locating pin in expansion frame to the hole in the tape library
floor.
• Align the top locating pin in the expansion frame to the top slot in the tape
library.
• Push the expansion frame firmly against the tape library frame (see Figure 3).
17. While holding the expansion frame in position, adjust the two leveling bolts closest to the
back until they touch the floor (see Figure 3).