Cartridge Access Port Installation Instructions

62104 2
■ CAP Install
1. Have the operator take the library and all tape drives offline and power off the tape library.
2. Obtain key and open front cartridge area door of the tape library.
3. Remove CAP A EMI SHIELD (refer to item 3 of the graphic) and window assembly from
CAP B mounting location and set aside. Use a T15 Torx driver. A total of 10 No. 6-32 x 3/
8-in. Torx Pan Head screws must be removed (see Figure 1).
Note: The CAP EMI SHIELD may only have six screws on some older 20/700
models.
Figure 1. Removing CAP A EMI Shield and Window Assembly