56 Cartridge Array Installation Instructions

ManualsBrandsHP ManualsStorageHP Surestore Tape Library Model 10/180

62213 1

HP Surestore Tape Library 10/180

56 Cartridge Array Installation

Instruction

(for HP Field Service Use Only)

CAUTION: Remote resolution must be attempted prior to authorization of on-site service.

Note to Customer Engineer: This installation may add new technology to the library

that older user’s guides do not address. Please remind the customer that the latest user

documentation is available from the HP Customer Care website: http://www.hp.com/go/

support.

■ Materials Included

■ Installation Notes

• Confirm with the customer System Administrator that the tape library can be powered

off.

• Observe proper power down and power on procedures, as described in the

Installation or Service Manual.

• If you install or replace a Cartridge Array, you must mark the appropriate box on the

Drive Location Label. The Drive Location Label is located on the inside of the rear

library door, just below the UL label.

Table 1. Materials List

Part Quantity

Cartridge Array Installation Guide 1

Cartridge Unit 1

6-cell Array 10

Retainer Clips 2

Retainer Labels 2

Summary of content (4 pages)

PAGE 1
HP Surestore Tape Library 10/180 56 Cartridge Array Installation Instruction (for HP Field Service Use Only) CAUTION: Remote resolution must be attempted prior to authorization of on-site service. Note to Customer Engineer: This installation may add new technology to the library that older user’s guides do not address. Please remind the customer that the latest user documentation is available from the HP Customer Care website: http://www.hp.com/go/ support. ■ Materials Included Table 1.
PAGE 2
■ Cartridge Array Install 1. Have the operator take the tape library and all drives off-line. 2. Go to the back of the machine and power OFF the tape library. 3. Open the front door with the tape library key. 4. Move the robotic hand to the top of the tape library, and rotate it towards the cartridge access port. Before beginning the installation procedure please note the bracket on the ceiling of the library so you don’t hit your head. 1.
PAGE 3
1. With the raised area of one retainer clip facing up, slide the prongs underneath the first cell of the top array in columns 3 and 4. Make sure that the lip on the front of the retainer clip is firmly fixed to the tape library wall by gently pulling the clip towards you to ensure that the retainer clip lock is snapped into position at the back array wall (see Figure 1). Figure 1.
PAGE 4
2. Remove the left theta stop from its current position (A), and install it at the new position (B), the center position, shown in Figure 2 CAUTION: This stop must be installed. If it is not, it could cause damage to the hand and/or the rear cover. Figure 2. Theta Stop 3. Close the front door of the tape library, and lock the latches. Power on the tape library. Verify that the tape library initializes and audits. If initialization and audit occurs, then the installation was successful.