HP Surestore Tape Library User's Guide

156 Diagnostic Support Tools Chapter 4
Running Library Diagnostic Tests
Use the following procedure to run internal tests of library functions. Table 28
on page 156 describes these tests.
1. From
Administration, select [More] to display additional administrative
options. Select
[Run Test].
2. From
Run Test, use the [-] or [+] key to view available tests.
3. Select
[OK] to select the test.
4. Select the number of times this test will run.
5. Select [Run] to start the test cycle. The test results will display at the
conclusion of the test cycle.
Note Select [Stop] to abort a test. The current test cycle completes
before the test stops. Stopping the test may take a few minutes.
Main Menu -> Administration -> Run Test
Table 28 Front Panel Diagnostic Tests
Test Description
Check Inventory Physically scans the entire library to determine
w
hich slots and drives contain tapes and reads all
bar code labels.
Recalibrate Library Performs the power-up self-tests. Each test runs one
t
ime per test loop. This test recalibrates the
mechanics and clears hard errors, but not the hard
error log.
Test Lateral Motion Moves the transport assembly to a random slot. No
t
ape is required.
Test Magazine
Mo
ves
Moves a tape from a random slot to an empty,
random slot, and then returns it to the original
location.