HP SureStore Tape Autoloader Model 1/9 Upgrade and Parts Replacement Guide

Replacing Autoloader Parts
Returning the Autoloader
Chapter 3 3-9
5. To prevent damage, lock the transport by running the Lock Transport
front panel test.
Figure 3-4 Removing the Front Magazine
NOTE Be sure to also remove the tapes from the internal back magazine.
CAUTION Do not power-off the autoloader until the interface is inactive. Removing
power from a SCSI peripheral when the bus is active can result in data
loss and/or indeterminate bus states. If your computer is connected to a
LAN, be sure to check with your system administrator before powering-
off.
6. Power-off the autoloader. The power “standby” switch is recessed to
avoid accidental power cycles. Disconnect the power cable.
7. Remove the drive module by following the procedures in “Removing
theDriveModule”onpage3-4.
8. Remove and keep all external cords, cables, and terminators.