HP SureStore Tape Autoloader Model 1/9 Upgrade and Parts Replacement Guide

Replacing Autoloader Parts
Removing and Installing Drive Modules
Chapter 3 3-5
5. Lay the connector assembly to the side, allowing the external cables
to hang from the connector. Do not disconnect external cables from
the connector plate.
6. Loosen the top and bottom thumbscrews on the drive module (Figure
3-2).
7. Using the handle that is mounted on the back of the drive module,
pull the drive module straight out with one hand while supporting
the bottom of the drive module with the other hand.
CAUTION As the drive module is pulled out, support the bottom of the drive module
to avoid dropping or damaging it.
Figure 3-2 Removing a Drive Module