HP SureStore Tape Autoloader Model 1/9 Upgrade and Parts Replacement Guide

Upgrading the Autoloader
Upgrading the Autoloader from DLT to Ultrium
Chapter 2 2-13
Removing the Back Magazine
CAUTION Use standard precautions for electro-static discharge (ESD) protection.
NOTE Running the Back Magazine Removal test from the front panel before
powering-offthe autoloaderplaces thetransport in thecorrect positionto
allow removal of the back magazine.
The internal, back magazine is removed through the access panel on the
right side of the autoloader. To remove the back magazine, do the
following:
1. If necessary, remove the standalone cosmetic cover (see “Removing
the Standalone Cosmetic Cover” on page 1-7).
2. Remove the side access panel by removing the four T-8 screws holding
thepanelinplace(seeFigure2-5).
Figure 2-5 Side Access Panel, Transport, and Back Magazine