HP SureStore Tape Autoloader Model 1/9 Upgrade and Parts Replacement Guide

Upgrading the Autoloader
Web Monitoring
Chapter 2 2-7
• IfDHCP/BOOTPwasnotsuccessfulorifyoudonotwanttouse
DHCP/BOOTP, contact your system administrator to obtain an IP
address, subnet mask, and gateway address.
NOTE The MAC address is unique to each remote management card and is used
for identification. This address cannot be configured. To successfully use
BOOTP from the autoloader, you must first configure the BOOTP server
using the MAC address.
6. Enter the desired IP address.
Use the
[+] keytochangethenumber.
Use the
[->] keytomovetothenextnumber.
Use the
[Down] keytomovetothenextaddress.
7. Enter the
subnet mask using the same procedure.
8. Enter the
gateway address.
9. Press
[OK] when complete to save the changes, or press [Quit] to exit
the menu and not save the changes.
A message will display to confirm the changes you have entered or
alert you if the changes have not been saved.
10.Enter the designated IP address into the web browser to launch the
browser.
Example 1 - All modes (Manual configuration, DHCP, or
BOOTP):
IP address = 15.28.33.12
http://15.28.33.12
Example 2 - With a DNS server present:
Device name = library1
http://library1
Your system administrator must add the device name you select to
the Domain Name Server (DNS).