HP SureStore Tape Autoloader Model 1/9 Upgrade and Parts Replacement Guide

Overview and Preparation for Upgrade
Removing a Rackmounted Autoloader (if necessary)
Chapter 1 1-5
ADVERTENCIA Antes de empezar, baje las patas de nivelación del bastidor y abra el
dispositivo estabilizador del mismo. En caso de no abrir el dispositivo
estabilizador, existe el peligro de que se produzcan lesiones personales
o daños al cargador automático de cintas si se vuelca el bastidor.
Removing the Autoloader from a Rack
To remove the autoloader from a rack, do the following:
1. Release the filler panel (and/or trim bracket) from the spacer bracket
by releasing the screws from the clip nuts located at the front of the
autoloader (see Figure 1-2).
2. Using two people or an appropriately rated lift, remove the
autoloader by gently sliding it toward the front of the rack.
3. Place the autoloader on a stable surface in preparation for upgrade.
Figure 1-2 Removing the Autoloader