60 - (English) User's Guide

Library Administration

Configuring the Library

Chapter 3 3-5

Library Administration

Enabling and Changing the Password

NOTE Administration procedures can be password protected. These procedures

include: diagnostic tests, configurations, online drive repair, and setting

the date and time. A password is also required for administration through

the remote management card.

When the library is first installed, the password is inactive. To protect

the system from unauthorized access, use the following procedure to set

a password.

1. Enter the

Password menu. A status screen will indicate if a password

is enabled.

• If the password is turned off, select

Set New Password to enable the

password.

• If the password is turned on, select Change Password to enter the

new password. It must be exactly eight digits.

• If the password is turned on, select Turn Password Off to clear the

password.

NOTE If you enter more than eight digits, the ninth digit will become the first

digit of the new password.

2. Select

[OK] to exit.

CAUTION Be sure to document the password. If you forget the password, contact

your service representative.

Main Menu ->

Administration ->

Change Configuration ->

Password