60 - (English) User's Guide

Library Installation

Moving or Shipping the Library

Chapter 11-54

NOTE You do not need to remove the SCSI cables that connect the controller or

the Fibre Channel interface to the drive modules, unless the library is

being shipped.

7. To move a stand-alone library, move it to its new location and

reconnect it using the procedures in “Connecting and Powering on the

Library” on page 1-24.

• For shipping, place the library in the original packing materials.

NOTE If you no longer have the original packaging, contact your service

representative to obtain packaging materials, or order direct from

Hewlett-Packard. The part numbers are listed in Table 1-5 on page 1-56.

• For libraries mounted in a rack, proceed to the next step.

8. Extend the rack’s anti-tip foot.

WARNING Failure to extend the anti-tip foot could result in personal injury

or damage to the library.

9. Open the magazine doors and loosen the screws that lock the library

into place (Figure 1-14 on page 1-22). The screws are located in front

of the trim brackets.

10.Remove the stop bracket. (See Figure 1-9 on page 1-18 and Figure

1-10 on page 1-19.)

11.Push the library out of the rack until it hits the latch stops

(approximately 2/3 of the library is out of the rack).

12.Reattach the lifting straps to the sides of the library.

13.Release the library from the rack.

• 40-Slot and 60-Slot Libraries:

Depress the latch stops at the top of the library with a screwdriver

or similar tool (Figure 1-26 on page 1-55).