60 - (English) User's Guide

Library Installation

Moving or Shipping the Library

Chapter 1 1-53

Getting Started

3. If shipping the library, remove tape cartridges from the magazines:

a. From the

Magazine Access menu, select one of the following

options:

— Unlock Door

— Unlock All Doors

Use the [-] or [+] keys to change the door selection.

b. Pull the unlocked door(s) out to access magazines and tapes. The

door may also be key locked. Unlock the door if needed.

c. Remove the magazine by lifting it straight up with the handle.

d. To remove a tape, set the magazine on its back and grasp the top

and bottom corners of the tape. Pull the tape straight out of the

magazine and return the magazine to the library.

4. If shipping the library, lock the transport:

a. From the

Administration menu, select the Run Test menu.

b. From

Run Test, use the [-] or [+] keys to select Lock Transport.

c. Select

[OK].

d. Select

[Run]. The front panel display will indicate that the

transport has been locked.

CAUTION Do not power off the library until the interface is inactive. Removing

power from a SCSI or Fibre Channel peripheral when the bus is active can

result in data loss and/or indeterminate bus states. If your computer is

connected to a LAN, be sure to check with your system administrator

before powering off the library.

5. Power off the library. The power “standby” switch is recessed to avoid

accidental power cycles.

6. To ship the library, remove all external cords, cables, and terminators.

For an internal move, only disconnect the power cables, SCSI cables,

the RMC ethernet cable, and the Fibre Channel connection from the

host, hub, or switch.