60 - (English) User's Guide

Library Installation

Identifying the Post-Installation Tasks

Chapter 1 1-51

Getting Started

Identifying the Post-Installation Tasks

After you install and configure the library, you must complete the

following setup tasks from the library’s front panel:

• Setting the date and time: When you first set up the library or if it

has been disconnected for an extended period of time (around 8 days),

set the library’s real-time clock. See “Setting the Date and Time” on

page 3-21 for more information.

• Setting the mailslot configuration: The default setting is for a

one-slot mailslot. You can select a 0, 1, 5, or 10-slot mailslot. See

“Configuring the Mailslot” on page 3-6 for more information.

• Configuring the library for web monitoring: You can monitor

and manage your library anywhere on the network through user-

friendly web pages. See “Using the Remote Management Card” on

page 3-9 for more information.

• Enabling the password: The library does not have a password

enabled when it arrives. To ensure security, enable and select a

password. Be sure to document this password. See “Enabling and

Changing the Password” on page 3-5 for more information.

NOTE You must first set a library password through the front panel to configure

the library using the remote management card (see “Enabling and

Changing the Password” on page 3-5).