60 - (English) User's Guide

Library Installation

Configuring the Host System

Chapter 11-46

MPE/iX Hosts

Requirements

Libraries require additional Legato NetWorker Server software that

runs on either an HP Intelligent Server or an NT Server. The HP 3000

must be a Legato Networker Storage Node.

Configuring the Host

The example below illustrates the steps needed to configure the library

on MPE/iX.

NOTE This example illustrates the driver binding, but is not optimized for

performance since it shows the entire library on a single differential bus.

NOTE The library ID of A4669A is used only as an example. The actual RUN

MAPPER output reflects the product number of your library.

1. Power on the library and host. Run ODE at the ISL prompt:

ISL>ODE

2. Identify the device path through RUN MAPPER:

ODE> RUN MAPPER

***STARTING EXECUTION OF MAPPER****

Processor Identification:

...

I/O Configuration:

Type HW SW Revisions

Path Component Name ID Mod Mod Hdwr Firm

...

/4/4 HP-PB Fast Wide SCSI . . .

/4/4.0.0 A4669A . . .

/4/4.1.0 DLT8000 . . .

/4/4.2.0 DLT8000 . . .

/4/4.3.0 DLT8000 . . .

/4/4.4.0 DLT8000 . . .