60 - (English) User's Guide

Library Installation

Configuring the Host System

Chapter 11-44

2. Determine the value for <majornum> by executing the following

command for robotics attached to an HSC or PCI adapter:

lsdev -d sctl

The output resembles the following:

Determine the value for <minornum> using the ioscan command. The

applicable lines in the ioscan output are those that refer to the

controller (contains the product name in the Description field) and

to the adapter (contains the ext_bus in the Class field).

For the HSC or PCI adapter, the ioscan output for the schgr driver

can differ in two ways, though either indicates successful device file

creation.

• If the schgr driver is configured on the system, this driver

appears to be associated with the library. The output would

resemble the following:

If the schgr driver is not configured on the system, no driver appears

to be associated with the library. The ioscan output line resembles:

Character Block Driver Class

HSC or PCI 203 -1 sctl ctl

Class I H/W Path Driver S/W State H/W Type Description

autoch 0 10/4/4.6.0 schgr CLAIMED DEVICE HP C7200-8000

Class I H/W Path Driver S/W State H/W Type Description

unknown -1 10/4/4.6.0 UNCLAIMED DEVICE HP C7200-8000