60 - (English) User's Guide

Library Installation

Configuring the Host System

Chapter 1 1-41

Getting Started

2. Type “init 0” at any prompt. This will shut down all processes, and

take you to the OpenBoot PROM.

3. Type “reset”.

4. At the OK prompt, type “probe-scsi-all”.

Run a test backup to ensure that all components are properly configured.

HP-UX Hosts

To enable communication between the host and tape library, appropriate

drivers must be configured into the HP-UX kernel. Table 1-4 shows

which drivers are necessary for each device.

NOTE Some drivers have different names, depending on whether or not they are

listed in the output of an ioscan or in the system file.

Table 1-4 Drivers Needed

Device Driver Name

In ioscan In system

file

SCSI Host Bus Adapter

(HSC or PCI Bus)

c720 c720

Fibre Channel Host Bus Adapter

fcp fcT1_fcp

fcT1 fcT1

fcT1_cntl fcT1_cntl

Fibre Channel Bridge or Multiplexer fcpmux fcpmux

Tape Library Robotics Controller

(HSC or PCI Bus)

sctl sctl

Tape Driver (HSC or PCI Bus) stape stape