60 - (English) User's Guide

Library Installation

Connecting and Powering on the Library

Chapter 11-36

6. Power on the hub or switch (if present).

NOTE The AC power cord is the library’s main AC disconnect device and must

be easily accessbile at all times.

7. Connect the power cord(s) from the library to a grounded power

receptacle. Power on the library by pressing the recessed power

(standby) switch located on the front of the library in the bottom right

corner. After the power-up test is complete (after several minutes),

you will see the Home Screen on the library’s front panel. The Home

Screen displays the status of the drives and library.

8. From the front panel, configure the library for Fibre Channel. See

“Configuring the Library for Fibre Channel” on page 3-15 for more

information.

9. Connect the remote management card (see “Using the Remote

Management Card” on page 3-9).

10.Power on the host.