60 - (English) User's Guide

Library Installation

Installing the Library into a Rack

Chapter 1 1-11

Getting Started

Rackmounting the Library (for HP Authorized

Personnel)

WARNING Before you begin, lower the rack’s leveler feet, and extend the

rack’s anti-tip foot. Failure to extend the anti-tip foot could result

in personal injury or damage to the tape library if the rack tips

over.

TIP To use the display panel and access the tape doors, mount the top of the

library in the middle of the rack or 120 cm (48 in) above the floor.

1. Use the template for your model library as a guide, and install five

clip nuts into each front column of the rack (Figure 1-3, Figure 1-4, or

Figure 1-5, depending on your library model). In Figure 1-4 and

Figure 1-5, the grey clip nuts indicate the position of the trim

brackets (see step 7). The upper grey clip nuts are used for racks with

a 55 mm bezel depth. The lower grey clip nuts are used for flush-

mount racks.

Use the template as a guide, and install four clip nuts into each back

column of the rack.