60 - (English) User's Guide

Library Installation

Installing a Stand-Alone Library in a Rack

Chapter 1 1-7

Getting Started

Installing a Stand-Alone Library in a Rack

NOTE For stand-alone installations, see “Connecting and Powering on the

Library” on page 1-24.

To install a stand-alone library in a rack, remove the cover and feet by

following these steps:

1. Remove the following six screws (Figure 1-1):

a. Four screws, one located at each of the four feet

b. Two screws near the bottom of the library and in the back

2. Lift the cover off the library.

NOTE The cover may fit tightly. If you cannot remove it easily, ease the sides out

while lifting up on the cover.

Figure 1-1 Removing the Cover