60 - (English) User's Guide

ManualsBrandsHP ManualsStorageHP Surestore E Tape Library Model 4/40

101

102

103

104

105

106

107

108

109

110

Library Administration

Configuring the Library

Chapter 3 3-13

Library Administration

4. If you would like to use DHCP/BOOTP to configure your remote

management card, select

[Yes]. (See “Dynamic Host Configuration

Protocol (DHCP)” or “BOOTP” on page 3-11.)

• A message will display to confirm your configuration through

DHCP/BOOTP, or alert you if DHCP/BOOTP failed.

• If successful, note the IP address, and skip to step 9.

• If DHCP/BOOTP was not successful, or if you do not want to use

DHCP/BOOTP, contact your system administrator to obtain an IP

address, subnet mask, and gateway address. Continue with

step 5.

NOTE The MAC address is unique to each remote management card and is used

for identification. This address cannot be configured. To successfully use

BOOTP from the library, your system administrator must first configure

the BOOTP server using the MAC address. (See “BOOTP” on page 3-11.)

5. Enter the IP Address.

Use the

[+] key to change the number.

Use the

[->] key to move to the next number.

Use the

[Down] key to move to the next address.

6. Enter the subnet mask using the same procedure.

7. Enter the gateway address.

8. Press

[OK] when complete to save the changes, or press [Quit] to exit

the menu and not save the changes. A message will display to confirm

the changes you have entered or alert you if the changes have not

been saved.

9. Enter the designated IP address into the web browser to launch the

Web-Based Library Administrator pages.

• Example 1 - All modes (Manual, DHCP, or BOOTP):

IP address = 15.28.33.12

http://15.28.33.12

• Example 2 - Manual and BOOTP only:

Device name = library1

http://library1