60 - (English) User's Guide

Library Installation

Configuring the Host System

Chapter 11-42

If these drivers are already installed into the kernel, upon system boot

they will automatically be associated with the hardware that they

control. However, if drivers are missing, they must be installed. For more

information on installing Fibre Channel drivers, refer to the HP Fibre

Channel Mass Storage Adapter Service and User Manual (A3636-90002).

A pass-through driver is used to manage the robotics controller. Since

this driver is not dedicated for this particular device, it must be

manually installed. The following sections describe this process:

• Installing the pass-through driver (below)

• Creating a device file for the robotics controller (page 1-43)

• Verifying the installation (page 1-45)

Installing the Pass-Through Driver

Obtain information about the peripherals attached to the system:

ioscan -f

The screen should look similar to the following:

Class I H/W Path Driver S/W State H/W Type Description

bc 0 root CLAIMED BUS_NEXUS

bc 1 8 bc CLAIMED BUS_NEXUS Pseudo Bus

Converter

ba 0 8/0 GSCtoPCI CLAIMED BUS_NEXUS PCI Bus Bridge -

GSCtoPCI

ext_bus 1 8/0/2/0 c720 CLAIMED INTERFACE Ultra Wide SCSI

target 3 8/0/2/0.0 tgt CLAIMED DEVICE

autoch 2 8/0/2/0.0.0 schgr CLAIMED DEVICE HP C7200-8000

target 4 8/0/2/0.1 tgt CLAIMED DEVICE

tape 2 8/0/2/0.1.0 stape CLAIMED DEVICE QUANTUM DLT8000

target 5 8/0/2/0.2 tgt CLAIMED DEVICE

tape 4 8/0/2/0.2.0 stape CLAIMED DEVICE QUANTUM DLT8000